Skirt belt vulcanizing repair
Skirt belt vulcanizing repair, Shanghai wanxu industrial belt Co., Ltd.
1. Conveyor belt wound grinding first marking wound contour (should is relatively large areas of damage), and then use the professional angle grinder, with moderate degree of tungsten steel grinding disc grinding, polishing to the wound site until certain radian and the process of surface damage position.
2 after brushing the surface clean and clean, and then use the brush to brush the glue, until the dry to a slight viscosity but not stick to the back of the fingers. If the wound site of the rubber is too large, should be filled with.
3 a patch that is attached to the wound site and inserts into the air. Then, to fill in the inside out of the rolling patch, then the bubble is compacted.
4 longitudinal tear is a common injury, severe cases, the entire conveyor belt to complete. If there is no effective repair material, for its strengthening, the case of the conveyor belt tension is inconsistent, extremely easy to cause damage.
5 kinds of traditional heat curing repair need to use a large curing machine, easy to operate, high cost, low efficiency. The use of conventional glue repair, but due to the effectiveness of time, can not solve the problem of penetrating damage.
Skirt belt vulcanizing repair, Shanghai wanxu industrial belt Co., Ltd.