Nylon conveyor belt (cold vulcanized joint)
Nylon conveyor belt
1 the adhesive tape according to the actual size, and the length of the joint is disconnected, recognize the following, the end of the conveyor belt with the elastic line to correct the tape connection center line. (use right angle horizontal line to verify the center line is correct) and draw the cutting dimension line
2 the preparation of the lower part of the tape: the two ends of the tape are overlapping each other to make the upper belt and the running direction, and mark the mark of the upper and lower part.
1) at the end of the tape, the CB line is drawn at a angle of 90 degrees, and the width of the adhesive tape is about 16 degrees to the tangent line.
2) in section (bottom) from the empty tape 30mm and draw a diagonal line parallel to the straight line, keep the tape edge, and mark. The marked 30mm wide strip of tape with a knife cut and tear to the cover layer slot part.