The conveying belt in transportation and storage, should be kept clean, avoid direct sunlight and rain leaching, prevent and acid, alkali, oil, organic solvent influence quality of rubber material contact, and distance heating device 1 meter. The storage warehouse should be kept in temperature between 15 DEG C - +40 DEG C, relative humidity should be maintained at 50 - 80%. 3 storage conveyor belt shall be placed into a roll, not folded, placed during turning once every quarter. The conveying belt running speed should not be greater than 5.0 M / sec, transport large blocks, the wear of materials and use of fixed plough type unloading device should as far as possible when adopting the slow speed. When the speed exceeds the specified speed, it will affect the service life of the adhesive tape. The conveyer driving drum diameter and conveying belt cloth layer, transmission drum to supporting roller and roller groove angle of the idler should be according to the conveying machine design rules, a reasonable selection. Just above, is to reduce the impact of the material on belt and wear and to the direction of feed should shun the running direction of the belt; the material falling onto the adhesive tape gap should be reduced as much as possible; feeding mouth should avoid roller or roller, rubber belt material receiving section should be shortened supporting and spacing and take measures to cushion. In order to prevent the scratch tape, block material scraper cleaning device and unloading material device and tape contact portion should be the proper hardness of rubber sheet, do not use clip cloth layer of the adhesive tape head.