Introduction to goes on belt conveyor device work pressure

Conveyor belt conveyor tail on automatic device is used to transfer machine and rapid passage along the trough belt conveyor tail and lap, conveyor belt machine tail on automatic device is used to transfer machine and rapid passage along the trough belt conveyor tail and lap, meet face high penetration, quickly promote the needs of conveyor belt manufacturers at the same time, the device has a belt running deviation adjustment, reprint machine direction alignment and moved forward on their own, and other functions.

Device used in high yield and efficient working face reproduced machine and trough belt conveyor connection. As it has since moved, adjust and alignment, and other functions, can satisfy the working face, penetration 10 meters above the use requirement; Its use in the belt width is 1 meter of the belt conveyor, roadway more than 4 m wide along the trough, 2.9 meters high.

The device powered by high pressure emulsion, the working pressure of 31.5 Mpa, so it is suitable for the fully mechanized working face gateway device; The machine head is the reproduced by bridge rotary frame and reproduced over the heads of the pattern in the vertical overlap connection pin, so the lower part of the nose should be reproduced machine is equipped with the corresponding tightening measures, while requiring reproduced frame bridge (meter) from the center has more than 10 meters length, reprint machine head height is 10 to 22 mm, the device for belt conveyor has the function of self tensioning tape.

The device before and after the main support department, leveling, ram, lateral cylinder cylinder, move the car and went on cylinder parts, at the same time equipped with hydraulic operating system. Tail of belt conveyor roller is set in the second half of the frame, in the mobile transfer machine, belt conveyor belt will not relax, avoid every mobile reproduced machine downtime must be conveyor tensioning tape, can be moved to the 3 m, mobile tail from the device in place of tensioning tape again.

Meet face high penetration, the need of fast forward, at the same time, the device has a belt running deviation adjustment, reprint machine direction alignment and forward on its own, and other functions.

Device used in high yield and efficient working face reproduced machine and trough belt conveyor connection. As it has since moved, adjust and alignment, and other functions, can satisfy the working face, penetration 10 meters above the use requirement; Its use in the belt width is 1 meter of the belt conveyor, roadway more than 4 m wide along the trough, 2.9 meters high.

The device powered by high pressure emulsion, the working pressure of 31.5 Mpa, so it is suitable for the fully mechanized working face gateway device; The machine head is the reproduced by bridge rotary frame and reproduced over the heads of the pattern in the vertical overlap connection pin, so the lower part of the nose should be reproduced machine is equipped with the corresponding tightening measures, while requiring reproduced frame bridge (meter) from the center has more than 10 meters length, reprint machine head height is 10 to 22 mm, thedevice for belt conveyor has the function of self tensioning tape.

The device before and after the main support department, leveling, ram, lateral cylinder cylinder, move the car and went on cylinder parts, at the same time equipped with hydraulic operating system. Tail of belt conveyor roller is set in the second half of the frame, in the mobile transfer machine, belt conveyor belt will not relax, avoid every mobile reproduced machine downtime must be conveyor tensioning tape, can be moved to the 3 m,mobile tail from the device in place of tensioning tape again.