The correct installation methods of conveyor belt

Pay attention to some of the conveyor belt installation problem, so will have to ensure the correct installation. The method of conveyor belt installed correctly:

(1) the volume to the conveyor belt core shaft to be flexible, before the stores should pay attention to the direction of the top and bottom cover rubber conveyor belt cannot reverse.

2 in order to prevent damage to the conveyor belt conveyor belt on the unfavorable on workplace can guide to open, and make the folding belt with large enough curvature radius. Fold place heavy objects on a conveyor belt is prohibited.

(3) can install the new conveyor belt with the old conveyor belt discharging simultaneously.

(4) level operation of conveyor, and tilt direction conveying confidential chosen cutoff point of operation, to prevent falling caused by gravity and out of control.

5] put in will the location of the new belt conveyor is, good use clamp to fix one end of the tape, then connected to the bypass roller ropes and pulleys, through traction device put on the conveyor, conveyor belt balanced traction, to prevent the conveyor belt and frame squeeze each other.

[6] use clamp to fix one end of the conveyor belt on the conveyor frame, the other end through the pulley to the other end of the taut, until the conveyor belt on the back roller has no obvious prolapse.

Once a final note is to tensioning device fixed from the starting point of 100 ~ 150 mm.